One-Handed Controller Modification for Xbox Series X|S

This inexpensive 3D printed modification for the Xbox Series X|S controller will allow for the user to operate their Xbox Series X|S controller with one hand. This controller modification snaps onto your existing Xbox Series X|S controller and allows you to use either your left or right hand to use both joysticks and access all of the main buttons.

Attribution

Designed by: Akaki

In partnership with The Controller Project

This controller modification allows users to operate their Xbox Series X|S controller with only one hand. There are two different versions included: one for left-handed and one for right-handed gamers.

When using the left-handed setup, the right joystick is controlled by moving the whole controller. When using the right-handed setup, moving the controller operates the left joystick. By moving the controller, the 3D printed parts enable the joystick to move simultaneously. In addition, the shoulder buttons are migrated to the left or right sides so all four shoulder buttons can be used with the index finger. Similarly, four 3D printed arms are used to allow the user to press the A, B, X, Y, and home buttons from the left side for vice versa. 

There are two different attachments for the bottom of the controller shown below that can be used depending on whether the user chooses to strap the controller to their leg (right), or can rest it on their lap or a surface of their choice using the “shoe” (left).

This video shows the controller modification in use.

This controller adaptation makes it easier for someone who may have a difficult time holding and using a controller with both hands, or has greater dexterity with one hand than the other.

This is a beginner level build that involves 3D printing and assembly.

Refer to the Maker Guide for detailed 3D printing instructions. For detailed assembly instructions, see this assembly video.

The Xbox Series X|S controller is asymmetrical, so this controller modification has different files for the left and right-handed modifications.

Print Settings: (Printables - One handed Xbox Series X|S Controller)

• 0.2 mm layer height
• 20% infill
• No Supports
• PLA can be used for all pieces. If possible, it is recommended to print the “shoe” piece in TPU, but if printed in PLA add rubber bands around the piece for additional grip.

Creative Commons Attribution-NonCommercial 4.0 International